Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 110 - Tire Selection and Rims. The French-language wording displayed on the tire placard does not … read more
On certain vehicles, corrosion may form in the lower steering column joint and limit the movement of the joint. Limited movement of this joint may create excessive load on the … read more
On certain vehicles the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction. The ECM relay may … read more
On certain Garmin nüvi 750 GPS units purchased as a customer or dealer installed accessory at Nissan dealerships, the lithium-ion batteries may contain a defect that may cause them to … read more
On certain vehicles, an improper wire insertion process during assembly resulted in an out-of-specification welding of the tether anchor wire to the seat gusset. The tether anchorage may not meet … read more
On certain vehicles, the lower control link assembly collars (forming the inboard attachment point to the chassis) may not have been manufactured correctly. If the collar weld fails, the cylindrical … read more
On certain four-wheel drive vehicles, the joint portion of the front driveshaft may contain small cracks. These cracks may eventually lead to a failure, resulting in separation of the front … read more
On certain vehicles, the fasteners securing the steering shaft positioning bracket may not have been tightened to the proper torque specification. If the fasteners are not properly tightened, they may … read more
On certain vehicles, the fasteners securing the passenger front air bag module may not have been tightened to the proper torque specification. If the fasteners were not tightened properly, they … read more
On certain vehicles, the molded fuel tanks are slightly thinner than specification in the area under the fuel sender unit. This may allow the tank floor to deform causing the … read more
ℹ️ By continuing to use this site, you are agreeing to the use of cookies as described in our Privacy Policy. ×