On certain vehicles, the fasteners securing the steering shaft positioning bracket may not have been tightened to the proper torque specification. If the fasteners are not properly tightened, they may … read more
On certain vehicles, the fasteners securing the passenger front air bag module may not have been tightened to the proper torque specification. If the fasteners were not tightened properly, they … read more
On certain vehicles, the molded fuel tanks are slightly thinner than specification in the area under the fuel sender unit. This may allow the tank floor to deform causing the … read more
On certain vehicles operated in areas of heavy road salt usage, the front Crash Zone Sensor (CZS) may rust internally. This could result in the non-deployment of the driver and … read more
On certain vehicles, inadequate coating of the fuel filler tube assembly could allow water to penetrate past the coating and cause surface rust. In areas which use heavy concentrations of … read more
On certain vehicles, some of the brackets used to attach the two gas struts to the rear door (hatch) may have been improperly made. At high ambient temperatures, the increase … read more
THE LATCH PLATE USED IN THE SEAT BELT BUCKLE MAY NOT HAVE BEEN MANUFACTURED ACCORDING TO THE DESIGN DIMENSION. THIS COULD RESULT IN PARTIAL ENGAGEMENT OF THE SEAT BELT BUCKLE … read more
NOTE: THERE ARE TWO DEFECTS IN THIS RECALL. (1) DUE TO THE THICKNESS OF THE CARPET PADDING ON THE TRANSMISSION TUNNEL, THE SPACE BETWEEN THE BRAKE PEDAL AND THE TRANSMISSION … read more
THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, … read more
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 120 - TIRE SELECTION AND RIMS FOR VEHICLES OTHER THAN PASSENGER CARS. INCORRECT LABELLING. read more
ℹ️ By continuing to use this site, you are agreeing to the use of cookies as described in our Privacy Policy. ×