Certain vehicles may have a condition which could result in one of the rear suspension trailing arm bolts breaking. If this were to occur while the vehicle was in motion, … read more
BECAUSE OF CERTAIN CALIBRATIONS IN THE AIR BAG'S COMPUTER, THERE IS AN INCREASED RISK OF AN AIR BAG DEPLOYMENT IN A LOW SPEED CRASH OR WHEN AN OBJECT STRIKES THE … read more
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 214 - SIDE DOOR STRENGTH. THERE MAY BE MIS-LOCATED WELDS AT THE JOINT BETWEEN THE LEFT ROCKER PANEL INNER REINFORCEMENT AND THE BODY … read more
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 101 - CONTROL LOCATION AND IDENTIFICATION. THE INTERIOR LAMPS MAY TURN ON BY THEMSELVES, FIVE TO THIRTY MINUTES AFTER THE VEHICLE IS STARTED … read more
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 110 - TIRE SELECTION AND RIMS. THE COMPACT SPARE TIRE ASSEMBLIES IN THESE VEHICLES MAY HAVE BEEN ASSEMBLED WITH RIMS THAT DO NOT … read more
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING EQUIPMENT. VEHICLES MAY EXHIBIT A CONDITION IN WHICH THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH … read more
Certain vehicles may not comply with CMVSS 1105 - Evaporative Emissions. Fuel injectors may exhibit leakage of fuel vapour due to a stress of the plastic encapsulant. Correction: fuel injectors … read more
NOTE: VEHICLES WITH AUTOMATIC TRANSMISSIONS. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 101 - CONTROL LOCATION AND IDENTIFICATION. THE INSTRUMENT PANEL TRIM PLATE MAY SAG AND COVER THE LIGHT EMITTING … read more
THE ACCELERATOR CONTROL CABLE MAY HAVE BEEN DAMAGED (KINKED) DURING VEHICLE ASSEMBLY. A KINKED ACCELERATOR CONTROL CABLE MAY RESULT IN HIGH PEDAL EFFORT, STICKING CABLE, OR BROKEN CABLE. IF THE … read more
THESE VEHICLES MAY HAVE BEEN BUILT WITH WELDS OMITTED FROM THE FRONT SUSPENSION LOWER CONTROL ARM ASSEMBLIES. THIS CONDITION COULD CAUSE EXCESSIVE LOADS ON EXISTING CONTROL ARM WELDS, AND COULD … read more
ℹ️ By continuing to use this site, you are agreeing to the use of cookies as described in our Privacy Policy. ×