On certain vehicles, the gearshift lever stud assembly may not have received adequate tighten torque during vehicle assembly. If the gearshift lever cable or stud assembly becomes loose, it may … read more
On certain vehicles equipped with power sliding doors, the sliding door wiring harness may have been routed improperly and chafe on the lower sliding door hinge bracket. This could result … read more
On certain vehicles equipped with a Heated Washer Fluid System (HWFS), a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. read more
On certain vehicles equipped with power sliding doors, the sliding door wiring harness may have been routed improperly and chafe on the lower sliding door hinge bracket. This could result … read more
On certain vehicles, the accelerator pedal pivot bearing bushings may dislodge from the pedal bushing bearing pockets and cause the accelerator pedal to bind or stick. Even though these vehicles … read more
On certain vehicles, the right and left front inner fender liners could contact the right front and left rear brake tubes respectively, which could cause a partial loss of braking … read more
Certain vehicles equipped with 20 inch wheels & tires may have incorect information listed on the tire information label. The label may erroniously state that the vehicle is equipped with … read more
On certain vehicles, the steering control Electronic Control Unit (ECU) programming for the Variable Gear Ratio Steering (VGRS) system can cause the steering wheel to become off-centered by up to … read more
On certain vehicles equipped with a 2.8L V6 engine, if low octane (regular) fuel is used in the vehicle instead of the required high octane (premium) fuel, as stated in … read more
On certain vehicles, the lower control link assembly collars (forming the inboard attachment point to the chassis) may not have been manufactured correctly. If the collar weld fails, the cylindrical … read more
ℹ️ By continuing to use this site, you are agreeing to the use of cookies as described in our Privacy Policy. ×